Waters In-Line Degasser AF 186001273 DG2 HPLC Solvent Management System (4976)

Waters In-Line Degasser AF 186001273 DG2 HPLC Solvent Management System (4976)Z Unit Powers on. Unable to test further. May require calibration. Good cosmetic condition. See pictures for more detail. Manufacturer: Waters Model #: In-Line Degasser AF 186001273 DG2 Specifications: Note* this data was taken from an online source and may not pertain to thisparticular model. Chemical resistant pH range 0 to 14 Gas removal efficiency Varies with flow rate Typical operating flow range 200 L/min to 5 mL/min Equilibration time <1 hour Pressure drop (across one channel) <0.08 psi (0.55 kPa) at 1 mL/min., Milli-Q water, STP Wetted surfaces PPSa , Teflon AFb , Tefzelc Inputs Enable, Disable (External control) Output dc voltage (Relative vacuum) Eluent connections 1/4-28 reversed ferrule fittings; 4 inlet and 4 outlet fittings Vacuum chambers One chamber/eluent, two channels standard, third or fourth channel optional; <0.5 mL internal volume/channel Tubular membrane 1/vacuum chamber, Teflon AF Vapor exhaust 1/8-inch (3 mm) barbed fitting Vacuum source Built-in 2-head diaphragm pump, solvent resistant Vacuum sensor Detects vacuum from 0 to 15.6 psiA Maximum pressure on inlet and outlets 10 psi (70 kPa) Power requirement 115 Vac (85 to 132 V), 50/60 Hz 230 Vac (187 to 264 V), 50/60 Hz Autosensing Ambient temperature 4 to 40 C (39 to 104 F) Relative humidity 10 to 90%, noncondensing The continuous running pump cycles between high-speed, to provide rapid vacuum pull-down, and low-speed, to sustain a consistent vacuum level This unique approach enables rapid vacuum equilibration for faster eluent equilibration The continuous operating mode improves chromatographic performance for high-sensitivity applications by eliminating detector baseline drift or cycling caused by pump hysteresis in discontinuous operating modes Dimensions: 5.25"(W) x 12"(D) x 5.75"(H) Weight: 7.5 lbs Sold as is with 30day Right of Return, only pictured items included Easy return/refund for any reason Anacapa Equipment RETURNS Anacapa Equipment Brokers, Inc. (Seller) strives to offer excellent customer service. You may return any equipment purchased from us for any reason within thirty (30) days after your receipt of the equipment for a full refund of the purchase price, provided that returned items are received in the same condition as sent. We DO NOT ship internationally. If you are using a freight forwarder then returns are VOID. SHIPPING All equipment purchased is shipped within one (1) business day (subject to freight availability) after receipt of payment and is shipped FOB place of shipment. We only charge actual shipping cost. If eBay overcharges for shipping, we issue an immediate refund for the difference. If you are undercharged, we will absorb the cost. We DO NOT ship internationally. IF you are using a freight forwarder then returns are VOID. LIMITED WARRANTY Buyer acknowledges that the equipment is being sold as is" and without any warranty of merchantability or fitness for a particular use. The entire risk as to the quality and performance of the equipment is with the Buyer. Should the equipment prove defective following its purchase the Buyer and not the Seller, manufacturer, distributor, or retailer assumes the entire cost of all necessary servicing or repair. Buyer may inspect the equipment prior to purchase and placement of the order. Failure to inspect prior to placement of an order is deemed a waiver of Buyers right to inspect. Buyer is responsible for determining the suitability of the equipment for its application. Seller assumes no liability for the use or misuse of any equipment purchased by Buyer. It is assumed that the equipment will be installed and operated by qualified personnel. The Buyer agrees that the Seller shall not be held responsible or liable for any injuries or damages, whether incidental or consequential, associated in any way with the equipment purchased. The Buyer, by purchasing this equipment, indicates its acknowledgment of, and agreement, to the terms of this limited warranty . INDEMNITY Buyer shall be solely liable for, and shall defend, indemnify, and hold Seller, its Affiliates, and all of their respective directors, officers, employees, agents, and independent contractors (Indemnitees) harmless from and against any and all damages, liabilities, injuries, losses, costs (including reasonable attorneys and experts fees at trial and on appeal), and expenses which may be incurred by, asserted against, or recoverable from any Indemnitee as a result of any actual or threatened action, suit or proceeding arising out of or relating in any way to the purchase of equipment from Seller. The validity and interpretation of this Agreement and the enforcement thereof shall be governed by the laws of the State of California without regard to any principles governing conflicts of laws. Any dispute arising from the purchase of equipment from Seller must be resolved in the State Courts of California.